Skip to main content

Product category

Decking & Support Machines

Wire mesh decking, flared channel and mezzanine floor deck lines for the surfaces that sit on the beams and turn a frame into a shelf.

All machines

Machines in this category

3 machines listed. Every one is built to order and test-run on material before it ships.

How to choose

Choosing within Decking & Support Machines

What decking has to do

Decking sits on the beams and turns a frame into a shelf. It carries the load, it stops small items falling through, and in a lot of installations it also has to look finished. Those three jobs pull in different directions, which is why there is more than one machine in this group.

Wire mesh decking is a U-channel with a welded mesh panel; the channel line forms the U, and the mesh is added afterwards. The flared channel variant turns the channel edges outward instead of inward, so the deck sits flush and the beam face stays clear for labels and beam locks.

Plain U or flared channel

A plain U-channel is the cheaper profile to form and the one most decking suppliers start with. The flared channel needs a slightly more demanding roll set because the flange turns through more than ninety degrees, but it removes the sharp edge that catches cartons and hands, and it lets the deck drop into the beam step without a separate fixing.

If your customers are in food, pharma or cold storage, the flared version is usually what the specification ends up asking for. If you are supplying general warehouse racking on price, plain U is the volume product.

Mezzanine deck is a different job

Mezzanine floor deck carries people, not pallets, and the panel is correspondingly deeper and stiffer with a locking detail between panels. It is not a scaled-up shelf panel: the roll set, the cut-off and the handling all differ, which is why it is quoted as its own machine rather than an option on a panel line.

One line can sometimes run more than one of these profiles if the strip width and the roll set allow it, but the changeover is a tooling change, not a setting change. Tell us the profile mix you actually sell and we will say whether one line covers it or you need two.

Compare all rack roll forming machines

Not sure which line fits your profile?

Send the section drawing, the material and the output you need. We will come back with the machine configuration that produces it — and say so if a different process would suit you better.

Talk to an engineer